Error code advise please

Well just had my 2004 c3 1.4 HDI 16v plugged in and have had errors cleared and lights out , all the problems arose after i shortened the actuator rod ( now put back to original )
THESE ARE THE CODES ANY ADVISE WOULD BE COOL and i have ordered a new air solenoid valve and will be cleaning out all air pipes and egr over weekend
is there any point blanking off egr valve ( did on my old discovery and was better )

CODES BELLOW BEFORE BEING CLEARED
P0215 / P0401 / P1351/ P0299/ P0400

Thanks Tim

1968unclefester wrote:CODES BELLOW BEFORE BEING CLEARED
P0215 / P0401 / P1351/ P0299/ P0400

Hi Tim,

Delete the codes, all of them that will go. They may be old, years old, but you have kept a copy above.

Then run the engine, take a test drive and read the codes again.

This way you get only current and fresh codes to deal with, other than ones from potentially, years ago.

The old ones are good to keep for future repeat problems diagnosis.

will do chears a friend reset them for me

have orderd a obd reader ( was cheap and may work ) so will check codes next week
still dosnt sort the low power fault that got me mucking with it in the first place
it seems realy flat till 3000 rpm then goes fairly well
like i said i have orderd a new electric air solonoid so will fit that as soon as poss
will be ok to blank the egr if its beyond cleaning
thanks Tim

1968unclefester wrote:will be ok to blank the egr if its beyond cleaning

Yes.

1968unclefester wrote:still dosnt sort the low power fault that got me mucking with it in the first place

Did you try disconnecting the MAF - Mass Airflow sensor electrical connection to see if it makes a difference to your lack of power below 3000RPM?

in the middle of changing the air solonoid and both the air pipes were disconected
so with the valve bolted to engine what port is for pipe going to turbo actuator
there is a white dot on one port on valve
chears Tim

The vacuum pipes to the EGR valve and turbo actuator valve on 16v HDi engine C3